Services

Coating and restoration, done the thorough way.

Every Wellman job across Muskegon County and West Michigan follows the same disciplined system — because a coating only lasts as long as the prep underneath it. Here's exactly what we do and why.

Proud Partner Sherwin-Williams

We apply professional-grade Sherwin-Williams coating systems, selected for the existing roof and project conditions.

What we do

Our coating & restoration services.

Liquid-Applied Roof Coating

The core of what we do. Sherwin-Williams elastomeric or silicone systems that cure into a continuous, reflective, protective membrane across a properly prepared roof — including compatible metal, EPDM, TPO and PVC systems on manufactured homes, RVs and campers, residences and small-commercial buildings.

Rust Treatment & Restoration

Rust never sleeps. We clean the surface, treat active corrosion, and prime bare metal so it's stable before a drop of coating goes down. Skip this step and the rust keeps eating the roof under a pretty white surface.

Seam & Penetration Sealing

Roofs leak at the details — seams, fasteners, vents, pipes, skylights and the roof edge. We reinforce and seal each one, then tie it all into the coating.

Inspection & Honest Assessment

Not every roof should be coated. We'll inspect yours and give you a straight answer. If a coating will serve you, we'll scope it. If it won't, you'll hear that up front.

What we coat

Existing roofs — restored, not replaced.

  • Existing metal roofs and manufactured & mobile home roof systems
  • Compatible EPDM, TPO and PVC membrane roofs, verified by inspection and coating-system requirements
  • Compatible RV & camper roof systems, including EPDM, TPO and PVC membranes where appropriate
  • Metal and low-slope roof systems on houses and small commercial buildings

What we don't do: shingle replacement, tear-offs, or structural roofing. Coating restores a sound existing roof — it isn't a substitute for one that's failed.

Rusted metal roof on a manufactured home, ready for restoration
The roofs we restore Rusted metal, still sound
Our process

How a Wellman roof comes together.

Assess

Brian walks the roof, photographs rust, seams, fasteners and penetrations, confirms coating is the right call, and measures for an exact quote.

Prepare

Clean and prepare the existing roof for the selected system. On metal, that can include treating active rust and priming bare areas; membrane roofs receive the compatible cleaning, detailing and primers required for their substrate.

Restore

Address seams, fasteners, penetrations and other details that apply to the roof, then install the selected coating system at the required application rate.

Document

You get before/after photos, the coating system used and the warranty terms — in writing.

The materials

Sherwin-Williams systems, matched to your roof.

Different roofs call for different systems. Elastomeric systems are designed to remain flexible through temperature changes. Certain silicone systems are well-suited to ponding-water exposure and UV conditions. Metal, EPDM, TPO and PVC each have their own preparation and compatibility requirements. As a Sherwin-Williams partner we spec professional-grade materials selected for the existing roof and conditions — and walk you through the choice so you know exactly what's going over your head.

Finished manufactured home roof with white reflective coating
Finished system Continuous protective membrane
Honest assessment

When restoration isn't the right call.

Coating isn't a cure-all. A roof may not be a candidate when the deck is structurally unsound, moisture is trapped inside the assembly, drainage can't be corrected, the substrate isn't compatible with the coating, or deterioration has progressed beyond a repairable condition.

If your roof isn't a sound candidate, Brian will tell you — before you spend a dime.

Backed in writing

Warranty, spelled out on every estimate.

Manufacturer material warranty

Your estimate names the exact Sherwin-Williams system going on your roof and the manufacturer warranty available for it — in writing, before any work starts.

Wellman workmanship warranty

Brian stands behind his prep and application. Your estimate states the workmanship warranty — how long it lasts and exactly what it covers.

Good questions

What homeowners ask us most.

What prep happens before the coating goes on?
Prep is most of the job, and it changes with the roof. Metal may require rust treatment and primer on bare areas; EPDM, TPO and PVC require cleaning, detailing and compatible primers or preparation steps for the selected system. Seams, penetrations and other vulnerable details are addressed before the field coating goes on.
How long does a coated roof last?
A well-matched, properly applied system can add years of service life. Expected performance depends on the existing roof, preparation, drainage, product system, application requirements and ongoing maintenance. Your estimate identifies the specific system and warranty, if applicable.
Can you coat over rust?
Often, yes — including on rusted metal mobile home roofs, as long as the metal underneath is still solid. We prepare and treat active rust and prime bare metal as required by the selected system. If corrosion has progressed beyond a responsible coating repair, we'll say so.
Do you coat EPDM, TPO and PVC roofs?
Yes. We work with compatible EPDM, TPO and PVC membrane roof systems as well as metal roofs. The existing membrane, its condition, previous repairs and the selected coating system all have to be compatible, so Brian verifies the roof before recommending a restoration scope.
Do you coat RV and camper roofs?
Yes. We can evaluate RV and camper roofs with compatible existing roof systems, including EPDM, TPO and PVC membranes where appropriate. Condition, previous repairs and coating compatibility are verified before a system is recommended. This service is for roof coating and restoration, not general RV or camper repair.
What about standing (ponding) water?
For roofs that hold water, silicone may be considered because certain systems are designed for ponding-water exposure. We match the coating system to the way the roof drains and the product requirements.
Free, no-pressure estimate

Not sure if your roof can be coated?

Send a photo or request a look. Brian will give you a straight answer — even if that answer is that coating isn't right for your roof.